• Gadget
  • Veteran Member
  • Offline
  • From: Burlington, Ontario
  • Registered: 2005-06-12
  • Posts: 63

Topic: Bilge pump through hull

When I had the hull repaired and gelcoated a small crack was discovered at a through hull on the aft starboard side at the waterline (see photo in the gallery). Three of use went over the boat and could find no use for the fitting so I had it removed. Do you think any of us noticed there was no exit for the bilge pumps! The problem now is I'm loath to drill another hole in my beautiful hull if I don't have to. Any thoughts or suggestions would be most appreciated. Is it possible to twin the bilge exit with another through hull perhaps?

                                                               Cheers
                                                                     John

.                               ,,,,,
                               (o o)
------------------oOO---(_)---OOo------------------
  • From: Vancouver, B.C. Canada
  • Registered: 2005-05-06
  • Posts: 304

Re: Bilge pump through hull

Could you not twin it to the galley sink through hull?

“You get a boat for only one reason, because you want one.  If you’re worried about being practical, forget boats.”
  • From: Ottawa, On
  • Registered: 2005-03-10
  • Posts: 353

Re: Bilge pump through hull

i'd put it back in - the bilge pump outlet thru hull is a dedicated one, and it's pretty big.  for one reason.  hopefully nobody ever has to find out why......

stefan_d's Website