• Registered: 2005-07-06
  • Posts: 1

Topic: what type of bow roller do you use on your CO 26?

Hi All,
I have recently purchased a Contessa and am putting together an anchoring system.
As my primary anchor, I will have a Delta Fast Set 22#, a 16.5 Bruce and a Danforth 11 pound.  All anchors will have chain/rope, but undecided at this point as to how much chain.

However,  the anchor rollers on the market don't seem to work with the stem fitting on her bow.  I am open to any suggestions and would appreciate your responses.  The trouble comes with trying to keep the anchor centered off the bow and not going off at an angle to the side with the bow roller.

I had been considering the BRM-4 by Windline with the three roller wheels.

Thanks in advance,
Susan

  • From: Barrie, Ontario, Canada
  • Registered: 2005-10-10
  • Posts: 237

Re: what type of bow roller do you use on your CO 26?

Check out the pics of my bow roller in the "Stemhead casting / forestay tang" topic in the "repair/modification/upgrade" area of this forum.