• From: Ile-Perrot, Quebec, Canada
  • Registered: 2005-09-11
  • Posts: 24

Topic: Petter AC1W - Hurth HBW10 Drive damper plate

I am looking for the damper plate bolted on the Petter flywheel, the transmission is a Hurth HBW10. Any idea where i could find it in Canada?

Outside diameter = 185 mm
Spring plate assy diameter = 125 mm
Bolt patern= M8 * 6 at 172mm C-C
Splines: 10 splines at 1 1/8 inch

Thanks.

Michel F's Website

  • Gadget
  • Veteran Member
  • Offline
  • From: Burlington, Ontario
  • Registered: 2005-06-12
  • Posts: 63

Re: Petter AC1W - Hurth HBW10 Drive damper plate

If it's a petters part you can try their Canadian distributor in Montreal 800-363-2259. I was dealing with a fellow named Guy there about one and a half years ago.

                                                               Best of luck
                                                                    John

.                               ,,,,,
                               (o o)
------------------oOO---(_)---OOo------------------

3 Reply by Michel F (edited by Michel F 2011-04-29 02:35:39)

  • From: Ile-Perrot, Quebec, Canada
  • Registered: 2005-09-11
  • Posts: 24

Re: Petter AC1W - Hurth HBW10 Drive damper plate

I have already contacted and the plate is not supplied by Petter. I have also tried on the Hurth side and same answer. It looks like if the plate has been supplied by the engine-transmission vendor.
.
Worst of all, the outside diameter and the bolt circle is not as per SAE.
.
Any idea?

Michel F's Website

  • Gadget
  • Veteran Member
  • Offline
  • From: Burlington, Ontario
  • Registered: 2005-06-12
  • Posts: 63

Re: Petter AC1W - Hurth HBW10 Drive damper plate

One more place you might try for part information and advice. I ordered an injector and pump from them and they were very good with advice. They also have good non-Petters knowledge of marine installations.

Mead Plant
Unit 5, The Park Estate
Bury Park Road
Luton
Bedfordshire
LU1 1HE

Tel: +44 (0) 1582 481022
Fax: +44 (0) 1582 488016

.                               ,,,,,
                               (o o)
------------------oOO---(_)---OOo------------------

5 Reply by Michel F (edited by Michel F 2011-09-10 16:07:09)

  • From: Ile-Perrot, Quebec, Canada
  • Registered: 2005-09-11
  • Posts: 24

Re: Petter AC1W - Hurth HBW10 Drive damper plate

Thanks, i will try.

Michel F's Website

6 Reply by Ian Malcolm (edited by Ian Malcolm 2011-05-10 00:14:22)

  • Registered: 2006-09-20
  • Posts: 175

Re: Petter AC1W - Hurth HBW10 Drive damper plate